PH-860 Pressurized nitrogen camera housing

IP68 High quality stainless steel camera housing

Large size housing 400mm internal length

Made of Stainless steel with stainless fittings

Multiple options, RJ45 connection, , bracket, heating, wiper, washer..

Description:

PH-860 stainless steel camera housing is a nitrogen pressurized camera housing. The use of nitrogen gas pressure in a camera housing ensure that no humidity is trapped in the camera housing, also the nitrogen gas has a cooling effect and the gas will equal the hotspots in the camera housing.

The IP68 seal ensure that no humididity, dust, water, pressurized water or anything from outside can enter the inside of the housing. The inside size of the housing makes it possible to install cameras with motorized zoom lenses.

The housing is made of stainless steel and all fittings are made of stainless steel.

The housing can be delivered with a selection of many options, RJ45 connection, heating, bracket, wiper, washer ...

	PH-860 pressurized camera housing
Height	180 mm
Width	164 mm
Length w/sunsheild	568 mm
Weigth	13,5 Kg
Voltages versions	AC230V or AC110V
Internal size (LxHxW)	400x110x130
Mounting plate	Metal rail
Material	SUS316L / SUS321
Plug	16 pin plug (optional RJ45 plug)
Window heater	Self regulating window heater
Pressure recommended	5-15 PSI Nitrogen
Temperature	-25 - +65° C
IP rating	IP68
Fit to pan tilt	PTS-518 stainless steel pan tilt

Options:

		Wiper The housing can be delivered with a externally mounted wiper motor and wiper arm. The wiper is turned on by supplying voltage to the motor and when turned off the wiper will self park in the side of the window, spray nozzle included.

		RJ45 network connector The housing can be delivered with a IP68 RJ45 network connector for IP cameras. The RJ45 connector is mounted above the IP68 16 pin connector.

		Active heater The housing can be delivered with a heater, not the standard window heater, but a heater element that heat up the inside of the housing to the temperture selected on the thermostat. The heat from the element is ventilated around the housing with a fan.

		Internal fan The housing can be delivered with a built-in fan to remove hot spots in the housing generated by camera heat or other sources of heat. The fan will equal the heat around the housing.

Image gallery:


	Stainless steel pressurized housing		16 pin connector and RJ45 connector


	Rear of camera housing		PTZ system with PH-860 with PTS-518

Downloads:

Download datasheet

Related equipment:

PTS-518 stainless steel pan tilt

Washer units

PTZ controllers

Zoom lenses

Cameras

Videos:

No videos at the moment.